Skip to content

Furnace Repair in Miami Springs, FL

Serving Miami Springs and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (645) 231-4348

The short answer

Most Miami Springs homes heat with electric heat strips or a heat pump rather than a gas furnace, and these systems often fail after sitting unused through the long cooling season. AirVantage Heating & Cooling finds the cause, such as a failed sequencer, a tripped limit switch, or storm-damaged controls, and explains your repair options before any work begins.

In Miami Springs, a "furnace" usually isn't a gas-burning unit in a basement. Most homes in the 33166 ZIP code heat with electric heat strips built into the air handler, or with a heat pump that runs the air conditioning cycle in reverse. A smaller number of homes have gas furnaces. All of these systems sit idle for months and then have to work on the first chilly morning of a winter cold front. When yours doesn't, AirVantage Heating & Cooling sends a technician from our Miami base, about 5 miles southeast of Miami Springs, to find out why and fix it.

Why Heating Fails After Months of Sitting Idle

Miami Springs runs its air conditioning for most of the year. The wet season, May through October, brings humidity and afternoon thunderstorms. November through April is drier and sunnier, and that's when an occasional cool snap sends homeowners to the heat setting. A heating system that hasn't run since last winter has had a long time to collect dust on its elements, lose a connection, or develop a fault that went unnoticed while the AC carried the load.

The first heating cycle of the year often produces a brief burning smell. That is usually dust burning off the heat strips, and it should fade within a short time. If the smell lingers, gets stronger, or smells like hot plastic or wiring, turn the system off and call for service. These are the problems we find most often in local homes:

  • Heat strips that don't turn on because of a failed sequencer, relay, or thermal limit switch
  • Tripped or worn breakers on the strip heat circuit
  • Heat pumps stuck in cooling mode because of a reversing valve or control board problem
  • Blower motors or capacitors worn down by a full season of cooling
  • Thermostats set up for cooling only, or with incorrect heat pump settings
  • Clogged filters that make the system overheat and shut itself off

How Storm Season Affects Your Heating Equipment

Hurricane season runs from June 1 to November 30, and summers in Miami-Dade County bring frequent lightning and power interruptions. Power surges and outages can damage control boards, sequencers, and thermostats in ways you may not notice while the system is cooling. Often the damage only shows up when you switch to heat. If your home lost power during a storm and the heat isn't working now, let us know. It helps us narrow down where to look.

Water is the other concern. Air handlers in garages or utility closets can be affected by flooding, or by a clogged condensate drain that overflowed during the humid months. Wet electrical components and heating elements should be inspected before you run them.

Quick Checks Before You Call

A few simple checks can rule out the most common causes. If none of these fix the problem, or if a breaker trips again after you reset it, stop there and schedule a repair.

  • Make sure the thermostat is set to Heat and the set temperature is above the current room temperature
  • Check the breakers for the air handler and the strip heat, which are often separate
  • Replace the air filter if it looks dirty
  • Make sure supply vents and the return grille aren't blocked by furniture or storage

What Happens During a Furnace Repair Visit

We start by confirming what type of heating equipment you have: electric strip heat, a heat pump, or a gas furnace. Next we check the basics, including thermostat settings, breakers, the filter, and airflow. Then the technician tests the heating components directly. That means measuring voltage and amperage at the heat strips, testing limit switches and sequencers, and confirming that a heat pump switches between cooling and heating correctly.

Before any work starts, we explain what failed, what it will take to fix it, and what your options are. Most of the time, replacing the one part that failed is the sensible choice. If a repair doesn't make sense for an aging system, we'll tell you plainly.

Repair or Replace: Rebates to Know About

If your heat pump is near the end of its service life, replacing it may be worth considering. Florida Power & Light offers rebates on qualifying high-efficiency central air conditioners and heat pumps. The rebates are delivered through participating contractors at the time of installation, and we confirm the current terms before including them in a quote. The federal Energy Efficient Home Improvement Credit covered only qualifying heat pumps placed in service before December 31, 2025, so it does not apply to new installations now.

Along with Miami Springs, we provide heating repair in Hialeah, Doral, West Miami, Medley, and Opa-locka.

More services in Miami Springs

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and track down what is actually wrong before suggesting a fix, so you are not paying for parts that don't solve the problem.

  2. Explain your options clearly

    We tell you what we found, what the choices are, and the tradeoffs of each, whether that means a repair, a tune-up or a replacement.

  3. Respect your home

    We protect floors and work areas, keep you updated as the job moves along, and clean up when we are done.

FAQ

Common questions

Don’t see your question? Call (645) 231-4348 and we’ll talk it through.

Do homes in Miami Springs actually have furnaces?

Some do, but most rely on electric heat strips in the air handler or on a heat pump. People often call any of these a furnace, and we repair all three types.

Why does my heat smell like something is burning?

A brief smell the first time you turn on the heat is usually dust burning off the heating elements. If the smell lasts, grows stronger, or smells like melting plastic or wiring, turn the system off and have it inspected.

My heat pump is blowing cool air in heat mode. What's wrong?

Air from a heat pump feels warm rather than hot, which is normal. If the air is clearly cold, the cause could be a thermostat setting, a stuck reversing valve, a control board fault, or heat strips that aren't turning on.

Is it safe to use the Emergency Heat setting?

Yes. Emergency Heat runs the heat strips without the heat pump, so it works as a short-term backup. It uses more electricity, so schedule a repair instead of relying on it for long.

Should I have my heating checked before a cold front arrives?

It's a good idea, especially if your home lost power during a storm or your air handler sits in an area that took on water. A check before cool weather lets you find problems before you need the heat.

Do you provide heating repair outside Miami Springs?

Yes. We also serve Hialeah, Doral, West Miami, Medley, and Opa-locka, along with Miami.

Tell Us What Your System Is Doing

Whether your AC is blowing warm air, your heat pump won't switch modes, or you're weighing a replacement, reach out and describe the problem. We'll schedule a visit, diagnose the issue and walk you through your options before any work begins.

Call (645) 231-4348 Request Service